Part Number Hot Search : 
12122 SC308 P2022 PD02N D78F9418 2SA2042 FF600 CEF85N75
Product Description
Full Text Search
 

To Download AH342-PL Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 AH342
Active High/Low Complementary Output Hall-effect Latch
Features
- Digital dual complementary sink/source outputs - Reverse Voltage Polarity protection for full supply range. - High output current capability - Low profile 4 pin SIP package
General Description
The AH342 is a bipolar latching hall IC with a pair of complementary push/pull outputs. A dual hall element is used to offset stress induced noise and drift. The robust outputs are capable of sourcing up to 7.4mA and sinking up to 4.4mA. The device contains inherent reverse polarity protection up to the full power supply range.
Applications
Conveyors Motor control Power sensing Linear or rotary motion detection RPM sensing
Pin Assignment
Front View
1 : Vcc 2 : DO 3 : DOB 12 3 4 4 : Vss
Pin Descriptions
Name Vcc DO DOB Vss P/I/O P O O P Pin # 1 2 3 4 Description Positive Supply Output Pin Output Pin Ground Power
342
Ordering Information
AH342 X - X X
Wafer Body Blank
Package P: SIP-4L
Lead L : Lead Free
*Packing: Bulk
This datasheet contains new product information. Anachip Corp. reserves the rights to modify the product specification without notice. No liability is assumed as a result of the use of this product. No rights under any patent accompany the sale of the product.
Rev.1.1 Sep 30, 2005 1/5
AH342
Active High/Low Complementary Output Hall-effect Latch
Block Diagram
OUTPUT AMP
7.5V 660
SOURCE
IO 510 SINK
Voltage Regulator Output Amp #1 Interface Circuit Output Amp #2 IO2 IO1
Hall Sensor
Amp and Trigger
Absolute Maximum Ratings (Note 1)
Characteristics Supply voltage Voltage Externally Applied to Output Output Current Magnetic Flux density Operation Temperature Storage Temperature Sym. VCC VOUT Ic B TOPR TSTG
o
Conditions -40 C to 125 C o o -40 C to 125 C No limit; the circuit cannot be damaged by magnetic overdrive No power applied
o
Values 28 -1.2 to 5 10 Unlimited -40 to 125 -40 to 150
Unit V V mA
C C
Note 1: Absolute maximum ratings are the extreme limits that the device will withstand without damage to the device. However, the electrical and magnetic characteristics are not guaranteed as the maximum limits (above recommended operating conditions) are approached nor will the device necessarily operate at absolute maximum rating.
Anachip Corp. www.anachip.com.tw 2/5
Rev.1.1 Sep 30, 2005
AH342
Active High/Low Complementary Output Hall-effect Latch
Electrical Characteristics (Note 2, 3)
Characteristic Sym.
Supply Voltage VCC Supply Current ICC Output Voltage #1 Sourcing #2 Sinking VOUT #1 Sinking #2 Sourcing Leakage (sink) ILeak(sink) Output Current #1 Sourcing #2 Sinking IOUT #1 Sinking #2 Sourcing Output Switching Time Fall Time Rise Time tf tr 90% to 10%; no load 28V0.5% Supply 10% to 90%; no load 28V0.5% Supply 1.0 s 1.0 Apply 2V to output and measure current. Switch magnetically operated, no load 28V0.5%. Apply 2V to output and measure current. Switch magnetically released, no load 28V0.5%. 5.5 2.8 2.8 5.5 7.4 3.4 3.4 7.4 8.0 4.7 4.7 8.0 5.0 2.4 2.4 5.0 7.4 3.4 3.4 7.4 8.5 5.0 mA 5.0 8.5
Conditions
28V0.5% supply Switch magnetically operated: No load 28V0.5% supply. Switch magnetically released: No load 28V0.5% supply. Apply voltage 0.2V greater than measured output source voltage measure current, no load 28V0.5% supply.
24oC 2oC Min Typ. Max
4.5 4 6.0 0 0 6.0 4.5 7.0 0.1 0.1 7.0 28 6 7.5 0.2 0.2 7.5 1.0
-40oC to 125 oC Units Min Typ. Max
4.5 3 4.5 28 7 1.0 V mA
V
A
Magnetic Characteristics( Ta=+25C) (Note 2, 3)
Characteristic Operate Point Release Point Hysteresis Sym. Bop Brp Bhy 24oC 2oC Vs=12Vdc 0.5%Vdc Min. Max. 40 120 -120 -40 120 200
o
(1mT = 10 Gauss) -40 oC to 125 oC Vs=4.5Vdc to 28Vdc Unit Min. Max. 30 150 Gauss -150 -30 Gauss 120 200 Gauss
o o
Note 2: All the parameters are tested under the 25 C only. The operation temperature (-40 C to 125 C) is guaranteed by design, it is typical value. Note 3: The magnetic field strength (gauss) required to cause the switch to change state (operate and release) will be as specified in the magnetic characteristics. To test the switch against the specified magnetic characteristics the switch must be placed in a uniform magnetic field.
Anachip Corp. www.anachip.com.tw 3/5
Rev.1.1 Sep 30, 2005
AH342
Active High/Low Complementary Output Hall-effect Latch
DO ( Output Voltage ) ( Output Voltage ) DOB
Vcc
( off-state )
( off-state )
Vcc
Turn off
Bhy
Turn on
Turn on
Bhy
Turn oFF
( on-state )
( on-state )
Vsat
Vsat S N Brp 0 Bop S ( Magnetic flux density B )
N
Brp
0
Bop
( Magnetic flux density B )
Performance Characteristics (SIP4)
Ta (C) Pd (mW) Ta (C) Pd (mW)
P d (m W ) 600 500 400 300 200 100 0 0 25 50 75 100 125 150 T a ( C )
25 550 105 198
50 440 110 176
60 396 115 154
70 352 120 132
80 308 125 110
85 286 130 88
90 264 135 66
95 242 140 44
100 220 150 0
P o w e r D is s ip a tio n C u rve
NoteSIP-4L package.
Operating Characteristics
DO ( Output Voltage ) S
Marking side
Vcc
High
Vd Bhy
Low
N ( SIP4 ) N
Vsat Brp 0 Bop S
( Magnetic flux density )
Anachip Corp. www.anachip.com.tw 4/5
Rev.1.1 Sep 30, 2005
AH342
Active High/Low Complementary Output Hall-effect Latch
Marking Information
( Top View ) Part Number
342
X XX A x
Wafer Lot ID: a~z is lead-free products Nth week: 01~52 Year: "1" = 2001 "2" = 2002 ~
Package Information
Active Area Depth
Marking side
Package Sensor Location
1.9714mm + 0.1mm 1.0460mm + 0.1mm
0.7mm
1
2
3
4
Package Dimension
5 -7 1.55mm +/-0.1mm 1.03mm +/-0.1 0.30mm +/-0.1mm 3 -5
o o o o
14.25mm +/-1.25mm 0.38mm +/-0.03mm
3.65mm +/-0.1mm
0.46mm +/-0.03mm
0.41mm +/-0.03mm 3.81mm +/-0.03mm
5.22mm +/-0.1mm 4.20mm +/-0.1mm
5 -7
o
o
3 -5
o
o
342
0.2mm Max. 1.42mm+/-0.1mm
1.27mm +/-0.03mm
Anachip Corp. www.anachip.com.tw 5/5
Rev.1.1 Sep 30, 2005


▲Up To Search▲   

 
Price & Availability of AH342-PL

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X